Search Site

You're currently on:

Hondata 4 Bar MAP Sensor K-Serie

Zoom Out
Zoom In

Hondata 4 Bar MAP Sensor K-Serie

• Hondata 4 Bar Map for K-series
• Connects directly to K-series engine harness
• A necessity for boosted engines where plenum pressure exceeds 11psi
€138.00
Add Items to Cart


Product Description

The Hondata 4 bar map sensor is a plug compatible replacement for the Honda factory MAP sensor. It is a direct replacement for the K-series Honda engines. This plug in sensor takes less than 60 seconds to install and eliminates the risk of sensor damage that often occurs when attempting to wire in other types of MAP sensors.

Wait, 4 bars of what?
The Bar is a measure of pressure, like PSI or Pascals. 4 bars is equal to (approximately) 58 PSI or 400 kPa. The stock Honda K series MAP sensor is only effective to about 11psi. So if you intend to run a turbo or supercharger setup that will approach or exceed around 11 pounds of boost, it is necessary to also use this MAP sensor so that your ECU can get accurate plenum pressure readings. Getting an accurate pressure reading is critical to maintaining a correct air/fuel ratio, because the reading that the MAP sensor sends the ECU is used to calculate exactly how much air is being forced into the engine.

What engines and vehicles will this work with?
The sensor is designed to work with most OEM K-series throttle bodies. It will also work on BDL throttle bodies designed for the K series motor.

The specific vehicles it will work with are the following (of course, it will also work in any engine swapped vehicles that have a motor from one of the cars in this list):

02-06 Acura RSX Type-S
01-06 Honda Integra DC5
02-05 Honda Civic EP3
05+ Honda S2000
01-05 Civic (all models)

Additional Information

SKU 4BMSK